Hi there,
I bought the suite with full source and I'm trying to customize siTransEditor.
I made changes to the form in the runtime package and compiled/built the source.
I compiled/build the design time package as well and installed the components again.
My changes don't show up when I launch the translation editor from the tsilang component on my products form.
Any help on this would be very much appreciated.
Cheers, Aidan.
Customizing siTransEditor
Re: Customizing siTransEditor
Hello,
Translations Editor is built into run-time package (TsiLang_XXr.bpl). When you install the suite the run-time package is also installed into [System] folder, like {Windows\System32}. So the most possible reason for your case is that the file from [System] folder is loaded instead of the new one. You can just delete/replace that file with your new version and it should work.
Translations Editor is built into run-time package (TsiLang_XXr.bpl). When you install the suite the run-time package is also installed into [System] folder, like {Windows\System32}. So the most possible reason for your case is that the file from [System] folder is loaded instead of the new one. You can just delete/replace that file with your new version and it should work.
Best regards,
Igor Siticov.
Igor Siticov.
Re: Customizing siTransEditor
Hi there,
Yes I found the file in the SysWOW64 folder.
When I replaced it my customization was available.
Many thanks,
Aidan.
Yes I found the file in the SysWOW64 folder.
When I replaced it my customization was available.
Many thanks,
Aidan.