Hello,
until now I used TsiLang without any problems. But now I added a new language: Russian. The translations was done with SilEditor and I could load the project (sil file). My application now shows Cyrillic letters!
But now the problem. As soon as I open the TsiLang Expert to change anything from the Delphi2009 IDE and change a bit and leave, the message box is shown - asking me to save or not. When choosing "save" all Cyrillic letters are gone and only question marks are visible.
I am using Delphi2009 Pro, TsiLang 6.3.1, German Vista.
I tried the option "StoreAsUTF8" - but the same problem occurs. As long as I don't change anything everything works. I can switch between languages and Russian comes up with correct Cyrillic letters.
I can use the SilEditor, but not the integrated expert in the IDE.
What is wrong here? Do I have to set a special option?
Problems with Unicode
I had exactly this problem with version 6.3.0.4 and StoreAsUTF8 set to False. I checked then with True and the problem wasn't soved. After that I updated to version 6.3.1, but didn't reset the StoreAsUTF8 property.
Now with 6.3.1 and unset StoreAsUTF8 it works! Thanks!
By the way: Where can I see the differences (changelog) between these versions (6.3.0.4 <-> 6.3.1)? Are there any notifications, that a new subversion 6.3.x is available?
Now with 6.3.1 and unset StoreAsUTF8 it works! Thanks!
By the way: Where can I see the differences (changelog) between these versions (6.3.0.4 <-> 6.3.1)? Are there any notifications, that a new subversion 6.3.x is available?