SIL Editor
Posted: Fri Oct 19, 2012 10:07 am
Hello,
If I use the 'Remove' command from the SIL Editor to delete one or more languages from an existing .sib file and afterwards load the resulting file into my application, then the number of languages is not read correctly. I found out that the TsiLang.FNumLang property is read correctly, but the TsiLang.LangNames property contains one language name too much (which then leads to the errornously stated number of languages). It seems as if the SIL Editor does not update the LangNames property correctly.
I am using the newest SIL Editor (ver. 6.0.0.41).
Kind regards,
Richard
If I use the 'Remove' command from the SIL Editor to delete one or more languages from an existing .sib file and afterwards load the resulting file into my application, then the number of languages is not read correctly. I found out that the TsiLang.FNumLang property is read correctly, but the TsiLang.LangNames property contains one language name too much (which then leads to the errornously stated number of languages). It seems as if the SIL Editor does not update the LangNames property correctly.
I am using the newest SIL Editor (ver. 6.0.0.41).
Kind regards,
Richard