Expert can not load a SIB into a form
Posted: Fri Aug 27, 2010 10:34 pm
Strange, very strange...
Today, my collegue tried to make a Load command to push new translations from a SIB into a Delphi-7 form (DFM).
The Load does not succeed, no feedback, no error message, the DFM was just not loaded???
Few seconds after the load, Delphi crashed with a popup windows asking to send the error to Microsoft.
He tried a few times to uninstall TsiLang and reinstall it with no success, always the same problem and crash.
He finally install the full source version of TsiLang and then everything works fine !?!?!?!?
Does anyone has already seen this strange behavior?
By the way, the SIB contains 2,400 records from which almost all of them differs from the contents of the form. These new values in the SIB are because I filled in the third language, last week. So the Load command has a great lot of job to do...
Today, my collegue tried to make a Load command to push new translations from a SIB into a Delphi-7 form (DFM).
The Load does not succeed, no feedback, no error message, the DFM was just not loaded???
Few seconds after the load, Delphi crashed with a popup windows asking to send the error to Microsoft.
He tried a few times to uninstall TsiLang and reinstall it with no success, always the same problem and crash.
He finally install the full source version of TsiLang and then everything works fine !?!?!?!?
Does anyone has already seen this strange behavior?
By the way, the SIB contains 2,400 records from which almost all of them differs from the contents of the form. These new values in the SIB are because I filled in the third language, last week. So the Load command has a great lot of job to do...