Error reading translationdata
Posted: Mon Jul 21, 2003 12:30 pm
Hi,
I recently registered silang component.
As my first translation project was nearly finished I stumbled a little on the following problem :
Most of of the units have a form and translation via the expert went well, including strings.
Two units did not have a form so I used the option 'without a Form' to solve the texts in this program part.
When pointing a Form to store the information I used a form in the project that is created last in the series of forms that is created.
This way I couldn't get the program to run again because the unit without form was trying to get translation information of a form that was not yet created.
As I was stuck I tried several things to get the program going again.
In the end this resulted in the error :
Exeption EReadError in module VCL30.dpl (using D3) at xxxxx
Error reading silang1.TranslationData :
List index out of bounds (76)
Uninstalling and reinstalling the package didn't help to solve the problem.
Even a small test project gives the same error.
What do I miss ? any clue ?
Best regards,
S.Nijssen
I recently registered silang component.
As my first translation project was nearly finished I stumbled a little on the following problem :
Most of of the units have a form and translation via the expert went well, including strings.
Two units did not have a form so I used the option 'without a Form' to solve the texts in this program part.
When pointing a Form to store the information I used a form in the project that is created last in the series of forms that is created.
This way I couldn't get the program to run again because the unit without form was trying to get translation information of a form that was not yet created.
As I was stuck I tried several things to get the program going again.
In the end this resulted in the error :
Exeption EReadError in module VCL30.dpl (using D3) at xxxxx
Error reading silang1.TranslationData :
List index out of bounds (76)
Uninstalling and reinstalling the package didn't help to solve the problem.
Even a small test project gives the same error.
What do I miss ? any clue ?
Best regards,
S.Nijssen